Page 1 of 2 12 LastLast
Results 1 to 10 of 13

Thread: MIJ Fender Jazz Bass muddy E string, is it the nut?

  1. #1

    User Info Menu

    MIJ Fender Jazz Bass muddy E string, is it the nut?

    My Jazz Bass is a MIJ 62 Reissue, 3 tone sunburst, with original Fender finger rest, pickup and bridge cover, and made in 1995, bought from Ishibashi U-box, November last year, which I really love to death.

    The problem now is the E string sounds like its 'grumbling' and too boomy and not punchy like the A, D and G strings, I already changed the strings about 3 times since I got the bass, but for the first 3 days after changing, it's really punchy and chimey but after 1 week, the E becomes muddy so fast, very annoying.. and I can't slap properly when it starts becoming like that, as if the string become stiff and not bright

    I read other forums and they suggest that my pickup's bass side may be too close to the strings, but mine are fine. and the string height looks ok. They also said the E string probably not seated well on the nut,

    When I check, the nut looks fine, except I can see some residual glue mark and and the place where the E sits, got a bit of worn out plastic bits coming out,

    I still have my other guitar serviced by Beez, and I havent ask him about my bass yet
    ,So is it really got problem with the nut? as in not cut properly perhaps?

  2. #2

    User Info Menu

    It could be a number of things as you already mentioned.
    It could be that the string is not sitting well in the nut or the bridge saddle, but check a few other things first as the below are more common causes;
    Check that the tuneing head is not loose and moving about (with normal string tension)
    Check if your string is too twisted at the bridge saddle. You can loosen the string just enough to be
    able to pull the end of it slightly away from the bridge, if it's twisted it will unwind itself.
    You mentioned your pickup high is fine, but might as well make sure; if the string sounds muddy unplugged, then it's definitely not te pickup height.
    If you can't find the cause, take it to a luthier.
    Good luck, hope you find out the reason soon.
    Oh and let us know when you do.

  3. #3

    User Info Menu

    The nut has no effect on the tone other than when u play an open string.

    Do you play the low E a lot more than the other strings? From what you're describing, the string is going dead fast. Wiping down the strings after you play helps.

    Btw what strings are you using?

  4. #4

    User Info Menu

    Wiping the strings somehow only give it only a few minutes of life before it turns back dead. The problem is I just change after 1 week and only played it for about 3-4 times, wiped the strings with a dry cloth and also keep the bass inside the bag with a pack of dehumidifier

    , and the strings currently D'Addario, previously was Ernie Ball and the original strings it came with from Japan, I always check the strings if they still have some power left by playing the RHCP higher ground slapping intro or Marcus Miller's run for cover intro

    I noticed that the brand new MIJ Fender Aerodyne Jazz Basses at TYMC at Peninsula, don't have this dead strings problem, and super punchy and better output, but the MIJ Marcus Miller Jazz Bass at Swee Lee has the strings problem just like mine, and it's so hard just to awaken the tone, like a stubborn donkey

    Even the MIM 60's RI and Standard Jazz basses have a better sound than my MIJ, which is a little embarrassing for me...
    Could it be just my bass didn't have a good setup, Beez is currently checking out what's the problem,

  5. #5

    User Info Menu

    strings get duller for slapping when they get worn in, nature of the beast. gotta deal w it

  6. #6

    User Info Menu

    Quote Originally Posted by littleboi View Post
    strings get duller for slapping when they get worn in, nature of the beast. gotta deal w it
    Really? I have strings that have been worn in for years but still sounding sparkling bright when slapped. As long as you maintain it right.

    Andrew, you realise most of the instruments sitting on Swee Lee's floor have been around for quite a while, and they don't usually get string changes. So if the MM has been there for 5yrs, the strings have been tarnishing for 5yrs, nothing to do with the model of the bass.

  7. #7

    User Info Menu

    The MM Jazz bass at Swee Lee, has a T serial number, so I'm sure that it's not more than 2 years old, but I believe it has a lot of potential, just like my bass. The tone I was looking for is to get that 'Piano' like sound, as in the sound you hear when you press the lower keys on the piano, I only get that tone if I just replaced the strings,

    So, if not the nut or the model of the bass, what exactly is the recommended way to maintain my bass, including wiping the strings, keeping it zipped up in the gigbag with a dehumidifier pack? plus, last time I used to keep it displayed in my air-con room, was this a big no-no?

  8. #8

    User Info Menu

    2 years of sitting around in the showroom is more than enough for the strings to go dead.

    Personally this is what I do to keep my strings sounding fresh. I have 2 sets of strings per bass that I own. Along with a round tupperware (which u can get for $2 from Daiso). I fill the tupperware with mineral/meth spirits, which you can get from Homefix or any DIY/hardware store.

    Whenever my strings go dead, I take em off, and soak em in the m spirits. Rotating between sets. They come out sounding like brand new.

    Some people have variations of this method, including boiling (which could introduce rust). I've tried several different ways, and found this to be the most efficient and hassle free.

    BTW, when you mean "piano" tone. I'm assuming you mean lots of clarity. Have you tried stainless steel strings like DR Hi Beams?

    Air con room storage is abit of a double edged sword in Singapore due to our high humidity. Although air con reduces the humidity, when you turn it off, the metal parts of your instrument accumulate condensation. Makes no sense to keep the air con running 24/7 just for this anyway.

    Anyhow, with string soaking, I just leave my instruments out in the open, no need to keep them in bags.

    Last edited by fretless6; 23-05-11 at 10:54 AM.

  9. #9

    User Info Menu

    When I found that the Ernie ball strings on my bass, were really dead, I changed back to the original strings that came with it from Japan, not sure what brand but the ends were wrapped with red silk cloth.

    Before I changed back to those strings, I did put them in a basin of hot water and left it for like 10 minutes and I can see all the dirt coming out in the water, and it really did gave back most of its life back when try them on again, but they didn't show signs of rust when I take a closer look after 1 week.

    I've been doing this for 7 times so far, but so far its becoming less and less effective and I realise I can't keep doing it forever, but I always keep these strings as an emergency set. The Ernie ball strings doesn't seem to revive even when I boiled them, very weird.


    You're right about that air-con with condensation issue, ever since I heard about it, I always keep it zipped in the gigbag, same for my guitars. I actually prefer to display them like yours, since they're my prized possessions, even cooler if they are hanged on the walls.

    My playing style is mostly pop and rock, but I like to do some slapping in between, I guess I'll take your word on the DR Hi-beams, hopefully it's a good change from D'addario and Ernie Ball.

    But what's the mineral oil called, to store the strings? are they expensive?


  10. #10

    User Info Menu

    Bass strings are made up of multiple layers of wrap wire. When u boil them, there may still be water that's trapped between the windings. Causing the string to rust from the inside.

    It's mineral spirits, or meth spirits. Not oil. It's basically alcohol with 0 water content. It's bout $2+ for bout 1 litre from homefix.

    Remember, water and metal do not mix. Avoid boiling.

Page 1 of 2 12 LastLast

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •